IROBOT ROOMBA I7 CLEAN BASE (AUTOMATIC DIRT DISPOSAL) Not Emptying
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
96%
CONF
|
Clean Base Dirt Disposal Bags (3-Pack)
The disposal bag acts as the primary filtration media; when the microscopic pores become saturated with fine dust, the 1000W vacuum motor cannot pull enough CFM to create the necessary pressure differential to move debris. This results in a 'system full' state even if the bag appears physically loose or only partially filled with large debris.
SKU: 4640170
|
|
|
2%
CONF
|
Replacement Washable Dust Bin with Evacuation Port
The i7+ specific bin features a green rubberized evacuation flap on the bottom. If this flap becomes warped, brittle, or obstructed, the seal between the robot and the Clean Base nozzle fails, causing a vacuum leak that prevents debris from being successfully extracted into the base.
SKU: 4639199
|
|
|
2%
CONF
|
Clean Base Automatic Dirt Disposal Assembly
If the vacuum motor fails to actuate entirely, the failure is typically located in the internal PCB or the 1000W motor itself (often due to moisture ingestion). Because iRobot does not provide granular internal service parts for the base housing, the entire assembly is the required resolution for electromechanical logic failures.
|
DIY Repair Guide
Watch exactly how to replace the Clean Base Dirt Disposal Bags (3-Pack).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.