IROBOT ROOMBA COMBO J9+ Plus Dock Empty Fail
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
AllergenLock Debris Bag
The evacuation system requires a specific CFM (Cubic Feet per Minute) to transport debris. A full or micro-clogged bag increases air resistance beyond the threshold of the dock's pressure sensor, causing a software-interrupted cycle to prevent motor overheat.
SKU: 4648034
|
|
|
4%
CONF
|
Replacement Debris Bin
The bin features a spring-loaded rubberized flap on the bottom that acts as a check valve. If the hinge mechanism is physically jammed by debris or the elastomer seal is deformed, the Clean Base suction cannot overcome the mechanical resistance to open the port, resulting in zero debris transfer.
SKU: 4785882
|
|
|
3%
CONF
|
Clean Base Evacuation Port Gasket
Vacuum efficiency is dependent on a tight seal between the robot and the dock. If the rubber gasket at the base of the dock is torn, dry-rotted, or improperly seated, the system suffers a loss of static pressure, preventing the vacuum from reaching the velocity required to pull debris through the internal ducting.
|
DIY Repair Guide
Watch exactly how to replace the AllergenLock Debris Bag.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.