GRAINFATHER G30 Pump Impeller Cleaning
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Kettle Filter with Silicone Cap
The G30 relies on a friction-fit silicone cap to seal the kettle filter against the pump intake. Over multiple brew cycles, thermal fatigue and grain-weight pressure cause the silicone to lose its seal or the filter to detach, allowing hop matter and grain husks to enter the pump housing. Replacing the filter assembly restores the integrity of the pump's primary defense, preventing the mechanical stalling of the magnetic impeller.
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Kettle Filter with Silicone Cap.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.