GRACO EXTEND2FIT Cup Holder Loose
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
92%
CONF
|
Replacement Cup Holder
The cupholder is secured via a high-interference snap-fit tab that must clear a molded rib in the seat's shell to lock into a static position. Looseness occurs when the locking lug has either sheared due to improper removal or failed to fully transit the lead-in ramp during assembly, preventing the tab from seating in its recessed pocket. A replacement part ensures the locking barb has the necessary structural integrity and sharp geometry required to maintain a permanent friction lock.
|
|
|
8%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Replacement Cup Holder.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.