GOAL ZERO YETI 1500X Not Detected
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
Yeti Link Expansion Module (V2)
The 'Not Detected' error is a specific communication timeout occurring within the expansion port interface. Older hardware revisions (SKU 98200) suffer from a logic lockup where the module fails to initiate the proprietary handshake with the Yeti 1500X's master controller. Replacing the module with the revised 98210 version resolves this firmware/hardware incompatibility and restores the DC-DC charging path.
SKU: 98210
|
|
|
10%
CONF
|
Yeti X 600W Power Supply
If the symptom occurs during AC charging, the power supply's internal switching regulator or the third-pin identification signal may have failed. The Yeti 1500X requires a specific data signal from the power brick to acknowledge its presence; without this signal, the input port remains in a 'Not Detected' or '0W' state even if current is potentially available.
SKU: 98350
|
|
|
5%
CONF
|
Internal MPPT Charge Controller Module
The internal Maximum Power Point Tracking (MPPT) board manages DC inputs from solar and 12V sources. A failure in the board's optocouplers or logic gates can prevent the main system from recognizing that a charging source has been physically connected to the High Power Port (HPP).
|
DIY Repair Guide
Watch exactly how to replace the Yeti Link Expansion Module (V2).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.