GE PROFILE PDT715SYNFS Error
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Water Inlet Valve
The H2O code triggers when the control board detects an incomplete fill within a specific time window. The inlet valve is the primary electromechanical gatekeeper; over time, the solenoid coil can suffer an open-circuit failure or the internal diaphragm can become obstructed by mineral deposits. Replacing this component restores the machine's ability to pull pressurized water into the tub.
SKU: WD15X26140
|
VIEW ON AMAZON
#CommissionsEarned
|
|
6%
CONF
|
Flood Float Switch
The float switch acts as a safety kill-switch for the fill cycle to prevent flooding. If the float becomes mechanically wedged in the 'up' position due to debris or detergent buildup, the electrical circuit to the inlet valve remains open, preventing the dishwasher from filling despite the control board calling for water.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
3%
CONF
|
Pressure Sensor (Transducer)
This sensor provides the feedback loop to the control board regarding the hydrostatic pressure (water level) in the sump. If the sensor's diaphragm is fouled by grease or the internal transducer fails, it will not report the correct water level to the control board, resulting in a timeout error even if some water is entering the machine.
SKU: WD21X25468
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.