GE PROFILE PDT715 Not Draining
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Drain Pump Assembly
The drain pump is a synchronous motor that uses a permanent magnet rotor to drive an impeller. If the internal seals fail, water enters the motor windings causing an electrical short, or debris physically jams the impeller, preventing the centrifugal force required to push water through the check valve and out the drain hose.
SKU: WD19X25187
|
|
|
5%
CONF
|
Pressure Sensor Assembly
This model relies on a pressure sensor to detect the hydrostatic head (water level) in the sump. If the sensor's diaphragm is fouled by fats/oils or the sensor fails electronically, the control board fails to trigger the drain sequence because it cannot verify the presence or absence of water, often resulting in a mid-cycle halt with standing water.
SKU: WD21X25468
|
|
|
4%
CONF
|
Fine Filter and Sump Screen
The fine filter captures particulate matter to protect the internal spray jets and drain pump. Over time, a buildup of calcium or organic biofilm can create a hydraulic seal that prevents water from entering the sump's drain intake, effectively starving the pump and preventing evacuation despite the pump motor functioning correctly.
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.