INSINKERATOR STANDARD GARBAGE DISPOSAL Leaking From Reset Button
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
95%
CONF
|
Garbage Disposal Assembly
Water exiting the reset button confirms a catastrophic failure of the internal dynamic shaft seal. This seal separates the fluid-filled grinding chamber from the dry motor compartment; once it fails, water migrates into the electrical housing. Because these internal seals are pressed-in during factory assembly and are not available as individual service parts, a full unit replacement is the only viable mechanical solution.
|
|
|
5%
CONF
|
Secondary Circuit / Wiring Check
Inspect wiring harness.
|
DIY Repair Guide
Watch exactly how to replace the Garbage Disposal Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.