FRIGIDAIRE FGEF306TMFD Error F10
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Oven Temperature Sensor Probe
The RTD sensor utilizes a specific resistance-to-temperature coefficient to communicate with the control board. If the internal ceramic substrate or the wiring connector develops high resistance or an intermittent open circuit, the control board interprets this as a rapid thermal spike. Replacing the probe restores the integrity of the feedback loop.
|
|
|
9%
CONF
|
Electronic Oven Control Board
The EOC contains the power relays that cycle the bake and broil elements. A 'stuck' or welded relay prevents the board from breaking the circuit once the set temperature is reached, causing a genuine thermal runaway. If the sensor is within spec, the logic board is the failure point for both power regulation and signal interpretation.
|
|
|
5%
CONF
|
Oven Sensor Wiring Harness
Corrosion or thermal fatigue at the molex connector where the sensor meets the main harness can introduce parasitic resistance. This skewed resistance value mimics a thermal runaway event to the microprocessor, triggering the F10 safety shutdown protocol.
|
DIY Repair Guide
Watch exactly how to replace the Oven Temperature Sensor Probe.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.