ELECTROLUX FRONT LOAD E11 Error Code
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
85%
CONF
|
Water Inlet Valve Assembly
The E11 code specifically triggers when the control board fails to detect a change in the water level frequency within a designated timeframe. This is most commonly caused by a failed solenoid in the inlet valve assembly which prevents water from entering the drum. Replacing the entire assembly ensures all solenoid coils and internal filters are refreshed.
SKU: 134190200
|
|
|
10%
CONF
|
Water Level Pressure Sensor
If the water inlet valve is successfully allowing water into the unit, an E11 code may persist if the pressure sensor fails to communicate the rising water level to the control board. A malfunction in the sensor's diaphragm or electronic transducer will cause the board to 'think' the machine is still empty.
|
|
|
5%
CONF
|
Stainless Steel Inlet Hoses
External to the machine, the inlet hoses or the small mesh screens within them can become obstructed by sediment or mineral deposits. This restriction reduces the GPM (gallons per minute) flow rate, causing the fill cycle to exceed the maximum allowable time, resulting in the E11 timeout.
|
DIY Repair Guide
Watch exactly how to replace the Water Inlet Valve Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.