DJI MATRICE 300 RTK Matrice 300 Rtk Propeller Vibration
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
2110s Propellers (CW/CCW)
Propellers are the primary source of rotational vibration due to aerodynamic imbalance or mass eccentricity caused by leading-edge nicks and structural fatigue. Replacing these every 200 flight hours is a mandatory maintenance requirement to prevent resonance that can damage the internal IMU and gimbal dampeners.
|
|
|
4%
CONF
|
M300 Propeller Mounting Adapter Kit
The quick-release mounting interface can develop mechanical play over time due to high-torque start/stop cycles. Even with balanced blades, a worn adapter allows the propeller to sit slightly off-axis, creating a centrifugal force imbalance that manifests as a high-frequency vibration during flight.
|
|
|
3%
CONF
|
DJI 3511 Brushless Motor
Internal ball bearing wear within the 3511 motor assembly results in increased run-out. This mechanical degradation introduces harmonic vibrations into the carbon fiber airframe, which can lead to airframe fatigue and 'jello' effects in the payload sensors if the bearings have surpassed their operational lifecycle.
|
DIY Repair Guide
Watch exactly how to replace the 2110s Propellers (CW/CCW).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.