BRYANT LEGACY 14 Ice On Coils Blowing Warm
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
96%
CONF
|
Pleated Air Filter (MERV 8-11)
A high-impedance or clogged filter reduces the volumetric flow of air across the evaporator coil. Without sufficient warm air to transfer heat to the refrigerant, the coil temperature drops below the dew point and subsequently the freezing point, leading to rapid frost accumulation and total airflow blockage.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
2%
CONF
|
Blower Motor Run Capacitor
The run capacitor provides the phase-shift necessary for the blower motor to maintain rated RPM. If the capacitor's capacitance (microfarads) drifts out of tolerance, the motor spins at a lower torque or fails to start, leading to insufficient airflow and subsequent evaporator icing.
|
VIEW ON AMAZON
#CommissionsEarned
|
|
2%
CONF
|
Thermostatic Expansion Valve (TXV)
The TXV regulates refrigerant flow into the evaporator; if the internal sensing bulb loses charge or the needle valve becomes restricted, the system will under-feed the coil. This creates a low-pressure environment in the evaporator, forcing the saturation temperature below freezing despite adequate airflow.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Pleated Air Filter (MERV 8-11).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.