BOSCH SHV878ZD3 Water In Bottom
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
86%
CONF
|
Drain Pump
The drain pump utilizes a synchronous motor to drive an impeller; if debris (such as glass or seeds) bypasses the filter, it can mechanically seize the impeller. Over time, the internal seals can also fail, allowing water into the motor windings and causing a loss of torque. This prevents the unit from overcoming the static head pressure required to lift water to the drain line.
SKU: 00631200
|
VIEW ON AMAZON
#CommissionsEarned
|
|
8%
CONF
|
Non-Return Valve (Check Valve)
This rubber flapper valve is designed to allow water to exit the sump while preventing dirty water in the drain hose from flowing back into the machine. If the valve is warped, coated in grease, or obstructed by debris, gravity will pull the wastewater from the high-loop back into the tub after the pump shuts off, resulting in standing water.
SKU: 00611323
|
VIEW ON AMAZON
#CommissionsEarned
|
|
6%
CONF
|
Fine Filter Assembly
The three-stage filtration system is the primary defense for the drain pump. If the mesh is torn or not seated correctly, solids enter the pump housing and impede the impeller's rotation. Replacing a damaged filter is a critical corrective measure to prevent recurring pump failure and ensure proper fluid dynamics during the drain phase.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Drain Pump.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.