BOSCH DISHWASHER ASCENTA SOAP DISPENSER Broken
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Detergent Dispenser Assembly
This is the complete integrated housing that includes the sliding door, the release latch, and the electrical wax motor actuator. Replacing the full assembly addresses the most common failure points where the internal spring snaps or the wax motor fails to retract the latch pin during the wash cycle. It is the standard service resolution for any physical breakage or failure to open.
SKU: 00645208
|
|
|
6%
CONF
|
Detergent Dispenser Slide Door
On Bosch Ascenta models, the dispenser uses a sliding door rather than a flip-open door. The plastic tabs on this slide can become brittle and snap, or the rails can become deformed, causing the door to fall off or jam. Replacing just the slide is effective if the housing and actuator are still functional.
|
|
|
3%
CONF
|
Dispenser Gasket/Seal
If 'broken' refers to a leak around the dispenser area, the internal seal between the dispenser body and the inner door panel may have failed. A compromised seal can also allow moisture into the actuator mechanism, leading to premature electrical failure of the release system.
|
DIY Repair Guide
Watch exactly how to replace the Detergent Dispenser Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.