BOSCH DISHWASHER 300 SERIES SOAP DISPENSER Broken
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Detergent Dispenser Assembly
This is the complete module including the sliding detergent door, rinse aid reservoir, and the release actuator. In the 300 series, the plastic latching lugs often snap or the internal wax motor/solenoid fails, preventing the door from opening or staying shut. Replacing the entire assembly ensures the new latch, spring, and electronic actuator are synchronized.
SKU: 00645026
|
|
|
4%
CONF
|
Dispenser Lid/Slide
If the 'broken' symptom is strictly limited to the plastic sliding cover being cracked or detached from its tracks, the lid can be replaced independently. This addresses physical damage to the exterior door without requiring the removal of the inner door panel to access the full assembly.
|
|
|
3%
CONF
|
Rinse Aid Cap
A common point of mechanical failure in the dispenser unit is the rinse aid cap, which uses small plastic tabs that easily snap off during refilling. If the user interprets 'broken' as the inability to seal the rinse aid compartment, this specific cap is the most likely culprit.
|
DIY Repair Guide
Watch exactly how to replace the Detergent Dispenser Assembly.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.