BOSCH B36CT80SN Temperature Fluctuating
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
93%
CONF
|
Temperature Sensor (NTC Thermistor)
The thermistor's resistive profile drifts over time due to thermal cycling, causing the control board to receive inaccurate data regarding the internal cabin temperature. This results in the compressor cycling at incorrect intervals, leading to the observed temperature swings. Replacing this sensor restores the precise feedback loop required for the dual-evaporator system.
SKU: 12022244
|
VIEW ON AMAZON
#CommissionsEarned
|
|
4%
CONF
|
Evaporator Fan Motor
The fan motor is responsible for convective heat transfer across the evaporator coils. If the motor windings degrade or the bearings experience high-friction events, the fan will fail to maintain the required RPM, preventing cold air from being distributed evenly throughout the compartment and causing localized temperature fluctuations.
SKU: 11033486
|
VIEW ON AMAZON
#CommissionsEarned
|
|
3%
CONF
|
Main Power Module (Control Board)
The power module acts as the logic center for the inverter compressors and fans. Failure of the on-board relays or microprocessor drift can result in the erratic execution of the cooling algorithm, where the board fails to respond correctly to sensor inputs even if the sensors themselves are within tolerance.
|
VIEW ON AMAZON
#CommissionsEarned
|
DIY Repair Guide
Watch exactly how to replace the Temperature Sensor (NTC Thermistor).
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.