ARLO ULTRA 2 SPOTLIGHT Wont Turn Off
| CONF | DIAGNOSIS | ACTION |
|---|---|---|
|
91%
CONF
|
Rechargeable Battery
The most common cause for a 'stuck' spotlight is a logic latch-up in the camera's firmware. Removing and reseating the battery forces a hard Power-On-Reset (POR) of the MCU and the LED driver circuit, clearing any volatile memory errors or hung GPIO states that are preventing the light-off command from executing.
SKU: VMA5400
|
|
|
5%
CONF
|
Spotlight Flex Cable Assembly
If the spotlight remains illuminated even after a factory reset, the failure mode is likely a hardware short within the flexible printed circuit (FPC). A physical breach in the insulation or a failure of the switching transistor (MOSFET) can create a permanent electrical bridge, allowing current to flow to the LEDs continuously without logic gate regulation.
|
|
|
4%
CONF
|
Arlo Outdoor Magnetic Charging Cable
Continuous AC power through a faulty or non-OEM charging cable can cause the camera to remain in an 'Active' or 'Streaming' state indefinitely. This prevents the device's light sensor and motion-trigger logic from cycling to the 'Inhibited' or 'Sleep' modes, keeping the integrated spotlight active as part of the 24/7 recording/lookback feature profile.
SKU: VMA5600
|
DIY Repair Guide
Watch exactly how to replace the Rechargeable Battery.
// NOTICE:
This report is generated by an Agentic AI Engineer utilizing probabilistic modeling.
PartSniper is an automated parts recommender service. AI-generated results may not be correct. This data is not a substitute for professional engineering advice or manual inspection. Always verify part compatibility and disconnect power before any repair. PartSniper is not liable for inaccuracies, injury, or damage.